Artisan software 4.0 - Linux Mint 21 - Hottop B-2K

B2K-00 To run artisan under Linux - must add user to dialout group
To run artisan under Linux - must add user to dialout group
B2K-01 Start with factory reset, then config roaster
Start with factory reset, then config roaster
B2K-02 Config / Machine for Hottop B-2K+
Config / Machine for Hottop B-2K+
B2K-03 Correct port for my B-2K is F230X Basic UART
Correct port for my B-2K is F230X Basic UART
B2K-04 Config / Machine - with no changes, success
Config / Machine - with no changes, success
B2K-05 Config / Autosave - Set up file naming and location
Config / Autosave - Set up file naming and location
B2K-10 Limited menu options under Standard Mode
Limited menu options under Standard Mode
B2K-12 Only see all menu options under Expert Mode
Only see all menu options under Expert Mode
B2K-13 Change sampling rate to three seconds
Change sampling rate to three seconds
B2K-15 Config / Curves / ROR - turn off projection of ROR
Config / Curves / ROR - turn off projection of ROR
B2K-16 Config / Curves / Filters - change smoothing
Config / Curves / Filters - change smoothing
B2K-17 Config / Curves / UI - Remove decimal places
Config / Curves / UI - Remove decimal places
B2K-18 Config / Axes
Config / Axes
B2K-19 Config / Device / Extra Devices eliminate LCD display for fan and heater
Config / Device / Extra Devices eliminate LCD display for fan and heater
B2K-20 Config / Device / Symb ET/BT - offset 4 degrees to match OLD B-2K+
Config / Device / Symb ET/BT - offset 4 degrees to match OLD B-2K+
B2K-21 Config / Events / Config - change default buttons and disable auto-DROP
Config / Events / Config - change default buttons and disable auto-DROP
B2K-22 Config / Events / Buttons do NOT change
Config / Events / Buttons do NOT change
B2K-23 Config / Events / Buttons do NOT change
Config / Events / Buttons do NOT change
B2K-24 Config / Events / Sliders change STEP to 10 for heater
Config / Events / Sliders change STEP to 10 for heater
B2K-25 Config / Events / Quantifiers change STEP to 10 for heater
Config / Events / Quantifiers change STEP to 10 for heater